6-8 x 20.5 egg, wide point back. Epoxy over PU with hemp deck and fin patches. Shown with a 7.5" fin I made out of G-10 (for the spine) and aircraft ply. This will be a 2+1, so I still have to build the sidebites, but when I do I'll be routing them into the blank. You can't see them under the tail patch but I installed HD PU inserts into the blank for the sidebites before I shaped the blank, and I used the hemp to cover them up. So the rout-in install completely skips the fillets at the base.
Love those little Nippon planes and 10'2"s
Surfituri te salutant!
nice work to all of the above!! love tuning in here occasionally to see the work you guys are doing.
Zack those look primo!
Lemat, Do you have instagram? spend a lot of time on there connecting with board builders so would be cool to get in touch?
gdaddy , Nice tail patch , clean looking work!
Been playing with linen and hand tie dyed deck inlays lately...
As you know, I took my hemp inspiration from you. Now you're doing prints, so that's a couple steps beyond.
wow. I need to get busy and do something. Ya'll have raised the bar significantly. All ya'll.
all the best
Personally I'm always ready to learn, although I do not always like being taught. - Winston Churchill
out of foam. so this was recycled from a board I made years ago, that sucked. good riddance :)
tail looks boxy in the pic, but its not. also theres a weird shadow around the leash plug. makes it look like its sunk. not the case.
cold water, warm heart
I like the shape. Looks much like a McCoy Nugget.
How does it surf?
Current project. Not all of the work done by me but man it's a big area to cover when your used to 5'6"
Sunshine Coast (hoax) Queensland Australia