I just finished putting on a 4th layer of epoxy on the deck (since I had a lot of ugly drippers on previous layer, my bad...) and hand sanded it. In attachment you find the result: glossy spots remain everywhere. Similar to the bottom (with which I had no dripping problems) but much worse.
1. How can I avoid this? It's a nice and warm temperature in the room and, at least with this last layer, I was very careful to remove all dust in the room and not touching it with my bear hands.
2. How can I make a layer that is thicker: For example, last layer I used a little less than 400 grs of epoxy but only about 1/2 ended up on the board (6'4'' wooden board) and I already sanded the equivalent of it completely off the board. I can see the fiberglass in some places (after 4 layers?!).
3. What do you recommend next? I'm not giving up on this time consuming and expensive board :-).