Dick Brewer Resin Tint/deck Inlay Lamination Video

Otis from Surf Factory Hawaii was nice enough to let us film him laying up a basic tint job on a couple of Dick Brewer Surfboards. Check it out;

http://compositecorner.wordpress.com/2013/08/12/how-to-glass-a-surfboard-with-tinted-resin/

Got a picture of how the finished board came out???

This video is a huge help. Nice work! I bet it took forever to make. Thanks for making it.  Btw…I don’t spend tons of money at your shop but every time I buy I am treated very well.  

Do you guys brush the laps after there sanded with some styrene or lam. Or is it just straight onto the deck lam ? 

A lot of guys do. As you know it helps it lay flat and get rid of the that white-ish color from sanding the laps. Some guys don’t because it can make the color bleed onto the foam which is a bummer if you’re going from a dark color to light or from a color to a white deck. It’s pretty easy to avoid that issue by not overdoing it on the styrene.

bitchin video way instructive

 clean audio and edit kudos.

…ambrose…

great 4a.m. fodder.