In a previous post, I asked if epoxy can be used for resin panels for my Thrailkill Pig project. The answer was yes. I started this thread as a more direct way to save the information for others in the future.
Any advice or tips? Anyone done this before?
I want to keep this old school in the vane of the pictures attached. I'll be using 6 oz volan cloth. I plan to apply a one inch red panel on either side of the stringer and then a 3 inch yellow panel outside of those.
I'll be using RR KK epoxy. I wonder if I need to thicken it a bit to keep it from flowing all over the place while it cures?
I think I should pull the tape when the epoxy curing is at the cheese consistancy stage?