Ok folks, rookie needs help! So after watching resin tint cut lap YouTube videos over and over, I was ready. However I made a last minute colour change and the the pigment tin said mix at 10% I thought that sounds a lot so went for about half that (about 70ml to 1200ml of resin) I used 1% mekp as suggested on green light. So I’m pretty much 24hrs later and it’s still not kicked, to be fair garage temp was probably too cold but figured it would still kick. It’s gone a little but not enough to flip the board without the glass pulling from the board when lifted from glassing stand ( I did try) I’ve left a heater on in the garage and come home for dinner. Any help appreciated on how to get out of trouble and get to a position I can trim the lap? I’m guessing it’s a combination of too much opaque pigment mixed with not enough catalyst in too cold temps?