I've had a miscut blank lying around for ages, and have decided to make it into something now i've got plenty of time on my hands. Only issue is there is a large channel cut into the centre of the blank, about 6 inches wide. It runs from the middle of the board back to the tail, gettting deeper and deeper until it's about 1/5 inch deep right at the tail.
Any suggestions for some creative bottom contours? I know vee is common in longboard tails but I think the rails will just be too thin....
Blank is 9'0 x 22 3/4 x 2 3/4, i'd like to shape it into a single fin general log mainly for use by my girlfriend.
Fairly new to this (second board), so any help welcomed.