I poured my first epoxy hotcoat last night, and may now qualify for the World's Shittiest Hot Coat Award.
I could probably chalk this one up to:
- Using spray paint on the deck.
- Poor surface prep.
- Using a shitty foam brush.
- Never performing a hotcoat in real life.
But then I wouldn't be able to blame anyone else. :D
This is my standup/prone board that I do want to get back on the water.
So, where I go from here...
I'm thinking I could sand all the way back down till the whole surface is uniform smooth. I think there's enough coverage that once it's uniform I could go up through the grits, then polish or use a floor sealer.
Or if there's not enough coverage, get a real brush, and run a test before doing another hot coat.
Or... Are there better options I should consider?